I replaced the TPS with a good used unit from the salvage yard.  I also replaced the intake air temperature sensor since the wire was sheared off.  The air flow meter has been swapped out because it was also sticking.

I have a list of things to do:

-First I’m going to check the TPS to make sure it is set right.
-test water temp sensor.
-set the L-R screw to the middle.
-try the fuel volume test.
-do a code check (I did see the archive and I bought 2 LEDs to check it)
-install better injector bleed-off setup

The existing injector bleed-off setup: