I was able to get a good start on the motor on Friday. I pulled the front off the car and pulled the wiring harness off the motor.

I set up a table to put all my upgrade parts on to keep them safe. I still need to move all my new parts to the table.

I pulled the subframe assembly out of the all wheel drive car on Saturday. I took a shortcut and cut the front brace so I wouldn’t have to raise it as high. I still need to install the FWD subframe into this car so I’ll be able to roll it onto a trailer for scrapping.

I was able to get this subframe pulled quite a bit faster than the first one due to the learning curve the first time around. I had intended to get quite a bit further along on Saturday but I ended up helping work on a 1996 Nissan Maxima instead and that took 12 hours.